EasyManuals Logo

Cisco SG350-10MP Administration Guide

Cisco SG350-10MP
762 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #142 background imageLoading...
Page #142 background image
8
Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4 116
Administration: Stack Management
This section describes how stacks are managed. It covers the following topics:
NOTE Stacking is only supported on the SG350 (except for the Sx350) and SG550 family of devices.
•Overview
Types of Units in Stack
Stack Topology
Unit ID Assignment
Master Selection Process
Stack Changes
Unit Failure in Stack
Software Auto Synchronization in Stack
Stack Management
Overview
Devices can either function on their own, or they can be connected into a stack of devices in
various stacking modes (see Stack Unit Mode).
By default, a device is always stackable, but has no port configured as a stack port. All the
ports in the devices are configured as network ports by default. A device without any stack
port can be thought of as the master device in a stack of only itself or as a standalone device.
To stack two or more devices, configure the desired network ports as stack ports in the devices
and connect the devices with the resulting stack ports in a ring or chain topology.
The devices (units) in a stack are connected through stack ports. These devices are then
collectively managed as a single logical device. In some cases, stack ports can become
members in a stack of Link Aggregation Groups (LAGs) increasing the bandwidth of the stack
interfaces. See Stack Port Link Aggregation.

Table of Contents

Other manuals for Cisco SG350-10MP

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco SG350-10MP and is the answer not in the manual?

Cisco SG350-10MP Specifications

General IconGeneral
ModelSG350-10MP
CategorySwitch
PoE Budget130W
Switching Capacity20 Gbps
Forwarding Rate14.88 Mpps
Power SupplyInternal
Ports8 x 10/100/1000 PoE+ + 2 x Gigabit SFP
MAC Address Table Size16K
Jumbo Frame Support9216 bytes
ManagementWeb-based, CLI, SNMP
Operating Temperature0°C to 45°C (32°F to 113°F)
Storage Temperature-20°C to 70°C (-4°F to 158°F)
Operating Humidity10% to 90% relative humidity, non-condensing
Storage Humidity5% to 95% relative humidity, non-condensing
Dimensions (W x D x H)279.4 x 170 x 44 mm (11.0 x 6.7 x 1.73 in)

Related product manuals