Cisco SG350-10MP Administration Guide

13
Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4 244
Spanning Tree
This section describes the Spanning Tree Protocol (STP) (IEEE802.1D and IEEE802.1Q) and
covers the following topics:
• STP Flavors
• STP Status and Global Settings
• STP Interface Settings
• RSTP Interface Settings
• Multiple Spanning Tree Overview
• MSTP Properties
• VLANs to a MSTP Instance
• MSTP Instance Settings
• MSTP Interface Settings
STP Flavors
STP protects a Layer 2 Broadcast domain from Broadcast storms by selectively setting links to
standby mode to prevent loops. In standby mode, these links temporarily stop transferring user
data. After the topology changes so that the data transfer is made possible, the links are
automatically re-activated.
Loops occur when alternate paths exist between hosts. Loops can cause switches to relay the
same packets indefinitely, resulting packets not arriving at their destination, Broadcast/
Multicast storms and reduced network efficiency.
STP provides a tree topology for any arrangement of switches and interconnecting links, by
creating a unique path between end stations on a network, and thereby eliminating loops.

Cisco SG350-10MP Specifications

General

Model	SG350-10MP
Category	Switch
PoE Budget	130W
Switching Capacity	20 Gbps
Forwarding Rate	14.88 Mpps
Power Supply	Internal
Ports	8 x 10/100/1000 PoE+ + 2 x Gigabit SFP
MAC Address Table Size	16K
Jumbo Frame Support	9216 bytes
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 45°C (32°F to 113°F)
Storage Temperature	-20°C to 70°C (-4°F to 158°F)
Operating Humidity	10% to 90% relative humidity, non-condensing
Storage Humidity	5% to 95% relative humidity, non-condensing
Dimensions (W x D x H)	279.4 x 170 x 44 mm (11.0 x 6.7 x 1.73 in)