Cisco SG350-10MP Administration Guide

Port Management
PoE
184 Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4
10
PoE
This section describes how to use the PoE feature.
NOTE PoE is only supported on standalone devices, meaning devices that are not part of a stack.
It covers the following topics:
•Overview
• PoE Properties
• Settings
• Statistics
• Green Ethernet Overview
Overview
A PoE device is Power Sourcing Equipment (PSE) that delivers electrical power to a
connected Pod Devices (PD) over existing copper cables without interfering with the network
traffic, updating the physical network or modifying the network infrastructure.
Features
PoE provides the following features:
• Eliminates the need to run 110/220 V AC power to all devices on a wired LAN.
• Removes the necessity for placing all network devices next to power sources.
• Eliminates the need to deploy double cabling systems in an enterprise significantly
decreasing installation costs.
Power over Ethernet can be used in any enterprise network that deploys relatively low-pod
devices connected to the Ethernet LAN, such as:
• IP phones
• Wireless access points
• IP gateways
• Audio and video remote monitoring devices

Cisco SG350-10MP Specifications

General

Model	SG350-10MP
Category	Switch
PoE Budget	130W
Switching Capacity	20 Gbps
Forwarding Rate	14.88 Mpps
Power Supply	Internal
Ports	8 x 10/100/1000 PoE+ + 2 x Gigabit SFP
MAC Address Table Size	16K
Jumbo Frame Support	9216 bytes
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 45°C (32°F to 113°F)
Storage Temperature	-20°C to 70°C (-4°F to 158°F)
Operating Humidity	10% to 90% relative humidity, non-condensing
Storage Humidity	5% to 95% relative humidity, non-condensing
Dimensions (W x D x H)	279.4 x 170 x 44 mm (11.0 x 6.7 x 1.73 in)