Cisco SG350-10MP Administration Guide

Multicast
IPv4 Multicast Configuration
270 Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4
15
STEP 8 For each interface, select its association type. The options are as follows:
• Static—Attaches the interface to the Multicast group as a static member.
• Dynamic—Attaches the interface to the Multicast group as a dynamic member.
• Forbidden—Specifies that this port is forbidden from joining this group on this VLAN.
• None—Indicates that the port is not currently a member of this Multicast group on this
VLAN. This is selected by default until Static or Forbidden is selected.
STEP 9 Click Apply. The Running Configuration file is updated.
IPv4 Multicast Configuration
The following pages configure IPv4 Multicast Configuration:
• IGMP Snooping
• IGMP Interface Settings
• IGMP VLAN Settings
•IGMP Proxy
IGMP Snooping
To support selective IPv4 Multicast forwarding, bridge Multicast filtering must be enabled (in
the Properties page), and IGMP Snooping must be enabled globally and for each relevant
VLAN in the IGMP Snooping page.

Cisco SG350-10MP Specifications

General

Model	SG350-10MP
Category	Switch
PoE Budget	130W
Switching Capacity	20 Gbps
Forwarding Rate	14.88 Mpps
Power Supply	Internal
Ports	8 x 10/100/1000 PoE+ + 2 x Gigabit SFP
MAC Address Table Size	16K
Jumbo Frame Support	9216 bytes
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 45°C (32°F to 113°F)
Storage Temperature	-20°C to 70°C (-4°F to 158°F)
Operating Humidity	10% to 90% relative humidity, non-condensing
Storage Humidity	5% to 95% relative humidity, non-condensing
Dimensions (W x D x H)	279.4 x 170 x 44 mm (11.0 x 6.7 x 1.73 in)