Cisco SG350-10MP Administration Guide

Administration: Discovery
Discovery - CDP
Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4 151
9
Discovery - CDP
This section describes how to configure CDP.
It covers the following topics:
• CDP Properties
• CDP Interface Settings
• CDP Local Information
• CDP Neighbors Information
• CDP Statistics
CDP Properties
Similar to LLDP, the Cisco Discovery Protocol (CDP) is a link layer protocol for directly-
connected neighbors to advertise themselves and their capabilities to each other. Unlike LLDP,
CDP is a Cisco proprietary protocol.
CDP Configuration Workflow
The followings is sample workflow for configuring CDP on the device. You can also find
additional CDP configuration guidelines in the LLDP/CDP section.
STEP 1 Enter the CDP global parameters using the CDP Properties page
STEP 2 Configure CDP per interface using the CDP Interface Settings page
STEP 3 If Auto Smartport is used to detect the capabilities of CDP devices, enable CDP in the
Properties page.
See Smartport Types for a description of how CDP is used to identify devices for the
Smartport feature.
To enter CDP general parameters:
STEP 1 Click Administration > Discovery - CDP > Properties.
STEP 2 Enter the parameters.
• CDP Status—Select to enable CDP on the device.

Cisco SG350-10MP Specifications

General

Model	SG350-10MP
Category	Switch
PoE Budget	130W
Switching Capacity	20 Gbps
Forwarding Rate	14.88 Mpps
Power Supply	Internal
Ports	8 x 10/100/1000 PoE+ + 2 x Gigabit SFP
MAC Address Table Size	16K
Jumbo Frame Support	9216 bytes
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 45°C (32°F to 113°F)
Storage Temperature	-20°C to 70°C (-4°F to 158°F)
Operating Humidity	10% to 90% relative humidity, non-condensing
Storage Humidity	5% to 95% relative humidity, non-condensing
Dimensions (W x D x H)	279.4 x 170 x 44 mm (11.0 x 6.7 x 1.73 in)