Cisco SG350-10MP Administration Guide

10
Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4 160
Port Management
This section describes port configuration, link aggregation, and the Green Ethernet feature.
It covers the following topics:
•Workflow
• Port Settings
• Error Recovery Settings
• Loopback Detection Settings
• Link Aggregation
• UDLD
•PoE
• Green Ethernet
Workflow
To configure ports, perform the following actions:
1. Configure port by using the Port Settings page.
2. Enable/disable the Link Aggregation Control (LAG) protocol, and configure the potential
member ports to the desired LAGs by using the LAG Management page. By default, all
LAGs are empty.
3. Configure the Ethernet parameters, such as speed and auto-negotiation for the LAGs by
using the LAG Settings page.
4. Configure the LACP parameters for the ports that are members or candidates of a dynamic
LAG by using the LACP page.
5. Configure Green Ethernet and 802.3 Energy Efficient Ethernet by using the Properties page.

Cisco SG350-10MP Specifications

General

Model	SG350-10MP
Category	Switch
PoE Budget	130W
Switching Capacity	20 Gbps
Forwarding Rate	14.88 Mpps
Power Supply	Internal
Ports	8 x 10/100/1000 PoE+ + 2 x Gigabit SFP
MAC Address Table Size	16K
Jumbo Frame Support	9216 bytes
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 45°C (32°F to 113°F)
Storage Temperature	-20°C to 70°C (-4°F to 158°F)
Operating Humidity	10% to 90% relative humidity, non-condensing
Storage Humidity	5% to 95% relative humidity, non-condensing
Dimensions (W x D x H)	279.4 x 170 x 44 mm (11.0 x 6.7 x 1.73 in)