EasyManuals Logo

Cisco SG350-10MP Administration Guide

Cisco SG350-10MP
762 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #492 background imageLoading...
Page #492 background image
Security
Storm Control
Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4 349
17
Local IP Address—Local IP address through which the device is offering the service.
Local Port—Local TCP port through which the device is offering the service.
Remote IP Address—IP address of the remote device that is requesting the service.
Remote Port—TCP port of the remote device that is requesting the service.
State—Status of the service.
The UDP Service table displays the following information:
Service Name—Access method through which the device is offering the UDP service.
Type—IP protocol the service uses.
Local IP Address—Local IP address through which the device is offering the service.
Local Port—Local UDP port through which the device is offering the service.
Application Instance—The service instance of the UDP service. (For example, when
two senders send data to the same destination.)
Storm Control
This section describes storm control. It covers the following topics:
Storm Control
Storm Control Statistics
When Broadcast, Multicast, or Unknown Unicast frames are received, they are duplicated, and
a copy is sent to all possible egress ports. This means that in practice they are sent to all ports
belonging to the relevant VLAN. In this way, one ingress frame is turned into many, creating
the potential for a traffic storm.
Storm protection enables you to limit the number of frames entering the device and to define
the types of frames that are counted towards this limit.
When the rate of Broadcast, Multicast, or Unknown Unicast frames is higher than the user-
defined threshold, frames received beyond the threshold are discarded.

Table of Contents

Other manuals for Cisco SG350-10MP

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco SG350-10MP and is the answer not in the manual?

Cisco SG350-10MP Specifications

General IconGeneral
ModelSG350-10MP
CategorySwitch
PoE Budget130W
Switching Capacity20 Gbps
Forwarding Rate14.88 Mpps
Power SupplyInternal
Ports8 x 10/100/1000 PoE+ + 2 x Gigabit SFP
MAC Address Table Size16K
Jumbo Frame Support9216 bytes
ManagementWeb-based, CLI, SNMP
Operating Temperature0°C to 45°C (32°F to 113°F)
Storage Temperature-20°C to 70°C (-4°F to 158°F)
Operating Humidity10% to 90% relative humidity, non-condensing
Storage Humidity5% to 95% relative humidity, non-condensing
Dimensions (W x D x H)279.4 x 170 x 44 mm (11.0 x 6.7 x 1.73 in)

Related product manuals