Cisco SG350-10MP Administration Guide

20
Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4 380
Security: SSH Server
This section describes how to establish an SSH session on the device.
It covers the following topics:
•Overview
• Common Tasks
• SSH User Authentication
• SSH Server Authentication
Overview
The SSH Server feature enables a remote users to establish SSH sessions to the device. This
is similar to establishing a telnet session, except the session is secured.
The device, as a SSH server, supports SSH User Authentication which authenticates a remote
user either by password, or by public key. At the same time, the remote user as a SSH client
can perform SSH Server Authentication to authenticate the device using the device public key
(fingerprint).
SSH Server can operate in the following modes:
• By Internally-generated RSA/DSA Keys (Default Setting)—An RSA and a DSA
key are generated. Users log on the SSH Server application and are automatically
authenticated to open a session on the device when they supply the IP address of the
device.
• Public Key Mode—Users are defined on the device. Their RSA/DSA keys are
generated in an external SSH server application, such as PuTTY. The public keys are
entered in the device. The users can then open an SSH session on the device through
the external SSH server application.

Cisco SG350-10MP Specifications

General

Model	SG350-10MP
Category	Switch
PoE Budget	130W
Switching Capacity	20 Gbps
Forwarding Rate	14.88 Mpps
Power Supply	Internal
Ports	8 x 10/100/1000 PoE+ + 2 x Gigabit SFP
MAC Address Table Size	16K
Jumbo Frame Support	9216 bytes
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 45°C (32°F to 113°F)
Storage Temperature	-20°C to 70°C (-4°F to 158°F)
Operating Humidity	10% to 90% relative humidity, non-condensing
Storage Humidity	5% to 95% relative humidity, non-condensing
Dimensions (W x D x H)	279.4 x 170 x 44 mm (11.0 x 6.7 x 1.73 in)