EasyManuals Logo

Cisco SG350-10MP Administration Guide

Cisco SG350-10MP
762 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #331 background imageLoading...
Page #331 background image
Spanning Tree
RSTP Interface Settings
Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4 251
13
Role—Displays the role of the port that was assigned by STP to provide STP paths. The
possible roles are:
- Root—Lowest cost path to forward packets to the Root Bridge.
- Designated—The interface through which the bridge is connected to the LAN,
which provides the lowest cost path from the LAN to the Root Bridge.
- Alternate—Provides an alternate path to the Root Bridge from the root port.
- Backup—Provides a backup path to the designated port path toward the Spanning
Tree leaves. This provides a configuration in which two ports are connected in a
loop by a point-to-point link. Backup ports are also used when a LAN has two or
more established connections to a shared segment.
- Disabled—The port is not participating in Spanning Tree.
Mode—Displays the current Spanning Tree mode: Classic STP or RSTP.
Fast Link Operational Status—Displays whether the Fast Link (Edge Port) is enabled,
disabled, or automatic for the interface. The values are:
- Enabled—Fast Link is enabled.
- Disabled—Fast Link is disabled.
- Auto—Fast Link mode is enabled a few seconds after the interface becomes active.
Port Status—Displays the RSTP status on the specific port.
- Disabled—STP is currently disabled on the port.
- Discarding—The port is currently discarding/blocked, and it cannot forward traffic
or learn MAC addresses.
- Listening—The port is in Listening mode. The port cannot forward traffic, and
cannot learn MAC addresses.
- Learning—The port is in Learning mode. The port cannot forward traffic, however
it can learn new MAC addresses.
- Forwarding—The port is in Forwarding mode. The port can forward traffic and
learn new MAC addresses.
STEP 8 Click Apply. The Running Configuration file is updated.

Table of Contents

Other manuals for Cisco SG350-10MP

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco SG350-10MP and is the answer not in the manual?

Cisco SG350-10MP Specifications

General IconGeneral
ModelSG350-10MP
CategorySwitch
PoE Budget130W
Switching Capacity20 Gbps
Forwarding Rate14.88 Mpps
Power SupplyInternal
Ports8 x 10/100/1000 PoE+ + 2 x Gigabit SFP
MAC Address Table Size16K
Jumbo Frame Support9216 bytes
ManagementWeb-based, CLI, SNMP
Operating Temperature0°C to 45°C (32°F to 113°F)
Storage Temperature-20°C to 70°C (-4°F to 158°F)
Operating Humidity10% to 90% relative humidity, non-condensing
Storage Humidity5% to 95% relative humidity, non-condensing
Dimensions (W x D x H)279.4 x 170 x 44 mm (11.0 x 6.7 x 1.73 in)

Related product manuals