EasyManuals Logo

Cisco SG350-10MP Administration Guide

Cisco SG350-10MP
762 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #514 background imageLoading...
Page #514 background image
Security
Denial of Service Prevention
Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4 371
17
The SYN Protection Interface Table displays the following fields for every port or LAG (as
requested by the user).
Current Status—Interface status. The possible values are:
- Normal—No attack was identified on this interface.
- Blocked—Traffic is not forwarded on this interface.
- Attacked—Attack was identified on this interface.
Last Attack—Date of last SYN-FIN attack identified by the system and the system
action (Reported or Blocked and Reported).
Martian Addresses
The Martian Addresses page enables entering IP addresses that indicate an attack if they are
seen on the network. Packets from these addresses are discarded.
The device supports a set of reserved Martian addresses that are illegal from the point of view
of the IP protocol. The supported reserved Martian addresses are:
Addresses defined to be illegal in the Martian Addresses page.
Addresses that are illegal from the point of view of the protocol, such as loopback
addresses, including addresses within the following ranges:
- 0.0.0.0/8 (Except 0.0.0.0/32 as a Source Address)—Addresses in this block refer
to source hosts on this network.
- 127.0.0.0/8—Used as the Internet host loopback address.
- 192.0.2.0/24—Used as the TEST-NET in documentation and example codes.
- 224.0.0.0/4 (As a Source IP Address)—Used in IPv4 Multicast address
assignments, and was formerly known as Class D Address Space.
- 240.0.0.0/4 (Except 255.255.255.255/32 as a Destination Address)—Reserved
address range, and was formerly known as Class E Address Space.
You can also add new Martian Addresses for DoS prevention. Packets that have a Martian
addresses are discarded.

Table of Contents

Other manuals for Cisco SG350-10MP

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco SG350-10MP and is the answer not in the manual?

Cisco SG350-10MP Specifications

General IconGeneral
ModelSG350-10MP
CategorySwitch
PoE Budget130W
Switching Capacity20 Gbps
Forwarding Rate14.88 Mpps
Power SupplyInternal
Ports8 x 10/100/1000 PoE+ + 2 x Gigabit SFP
MAC Address Table Size16K
Jumbo Frame Support9216 bytes
ManagementWeb-based, CLI, SNMP
Operating Temperature0°C to 45°C (32°F to 113°F)
Storage Temperature-20°C to 70°C (-4°F to 158°F)
Operating Humidity10% to 90% relative humidity, non-condensing
Storage Humidity5% to 95% relative humidity, non-condensing
Dimensions (W x D x H)279.4 x 170 x 44 mm (11.0 x 6.7 x 1.73 in)

Related product manuals