Cisco SG350-10MP Administration Guide

Security: 802.1X Authentication
Overview
Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4 359
18
Authentication Method and Port Mode Support
The following table shows which combinations of authentication method and port mode are
supported.
Legend:
†—The port mode also supports the guest VLAN and RADIUS-VLAN assignment.
N/S—The authentication method does not support the port mode.
NOTE You can simulate the single-host mode by setting Max Hosts parameter to 1 in the Port
Authentication page.
Authentication Methods and Port Modes
Authentication
Method
Single-host Multi-host Multi-sessions
Device in L3 Device in L2
802.1x † † † †
MAC††††
WEB N/S N/S N/S †

Cisco SG350-10MP Specifications

General

Model	SG350-10MP
Category	Switch
PoE Budget	130W
Switching Capacity	20 Gbps
Forwarding Rate	14.88 Mpps
Power Supply	Internal
Ports	8 x 10/100/1000 PoE+ + 2 x Gigabit SFP
MAC Address Table Size	16K
Jumbo Frame Support	9216 bytes
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 45°C (32°F to 113°F)
Storage Temperature	-20°C to 70°C (-4°F to 158°F)
Operating Humidity	10% to 90% relative humidity, non-condensing
Storage Humidity	5% to 95% relative humidity, non-condensing
Dimensions (W x D x H)	279.4 x 170 x 44 mm (11.0 x 6.7 x 1.73 in)