Cisco SG350-10MP Administration Guide

Security: IPv6 First Hop Security
Configuring IPv6 First Hop Security through Web GUI
459 Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4
26
- No Limit—Disables verification of the lower boundary of the hop count limit.
- User Defined—Verifies that the hop-count limit is greater than or equal to this value.
• Maximal Hop Limit—Indicates if the RA Guard policy checks the maximum hop limit
of the packet received.
- Inherited—Feature is inherited from either the VLAN or system default (client).
- No Limit—Disables verification of the high boundary of the hop-count limit.
- User Defined—Verifies that the hop-count limit is less than or equal to this value.
The value of the high boundary must be equal or greater than the value of the low
boundary.
• Minimal Router Preference—This field indicates whether the RA Guard policy will
verify the minimum advertised Default Router Preference value in RA messages within
an RA Guard policy.
- Inherited—Feature is inherited from either the VLAN or system default (client).
- No Verification—Disables verification of the low boundary of Advertised Default
Router Preference.
- Low—Specifies the minimum allowed Advertised Default Router Preference value.
The following values are acceptable: low, medium and high (see RFC4191).
- Medium—Specifies the minimum allowed Advertised Default Router Preference
value. The following values are acceptable: low, medium and high (see RFC4191).
- High—Specifies the minimum allowed Advertised Default Router Preference
value. The following values are acceptable: low, medium and high (see RFC4191).
• Maximal Router Preference—This field indicates whether the RA Guard policy will
verify the maximum advertised Default Router Preference value in RA messages within
an RA Guard policy.
- Inherited—Feature is inherited from either the VLAN or system default (client).
- No Verification—Disables verification of the high boundary of Advertised Default
Router Preference.
- Low—Specifies the maximum allowed Advertised Default Router Preference value.
The following values are acceptable: low, medium and high (see RFC4191).
- Medium—Specifies the maximum allowed Advertised Default Router Preference
value. The following values are acceptable: low, medium and high (see RFC4191).
- High—Specifies the maximum allowed Advertised Default Router Preference
value. The following values are acceptable: low, medium and high (see RFC4191).

Cisco SG350-10MP Specifications

General

Model	SG350-10MP
Category	Switch
PoE Budget	130W
Switching Capacity	20 Gbps
Forwarding Rate	14.88 Mpps
Power Supply	Internal
Ports	8 x 10/100/1000 PoE+ + 2 x Gigabit SFP
MAC Address Table Size	16K
Jumbo Frame Support	9216 bytes
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 45°C (32°F to 113°F)
Storage Temperature	-20°C to 70°C (-4°F to 158°F)
Operating Humidity	10% to 90% relative humidity, non-condensing
Storage Humidity	5% to 95% relative humidity, non-condensing
Dimensions (W x D x H)	279.4 x 170 x 44 mm (11.0 x 6.7 x 1.73 in)