3. Installation and
Configuration
This chapter describes the steps for downloading, installing and configuring the CallConnector
Operator Standalone and Client. The following topics are discussed:
Installation Overview - Provides an overview of the CallConnector
Operator client and standalone installation
process.
Pre-requisites for Installation - Describes the information you need to have on
hand during the installation of the CallConnector
Operator client and standalone.
Configurations on Router - Describes the features and services that need to
be setup on the Cisco Router for the
CallConnector Operator.
Minimum System Requirements - Describes the minimum hardware and software
required to run the CallConnector Operator.
Download Site - Site from which the CallConnector Operator
software can be downloaded.
Installing CallConnector Operator - Describes the steps and options for installing
CallConnector Operator.
Configuring CallConnector Server - This section provides the steps for configuring
CallConnector Operator in Standalone mode. It
refers installers to the Administrator’s Guide.
Performing an Upgrading - Describes the steps for upgrading an existing
CallConnector Operator with a new install
program.
Removing CallConnector Operator - This section describes the steps for removing
and un-installing the CallConnector Operator
program and all its components.
Troubleshooting - Describes the steps for resolving installation and
configuration issues.
CHAPTER
To Next Page
Loading...
