Cisco vEdge Series User Manual

Reset Button
The front panel of the vEdge router has a Reset button. The Reset button is recessed to avoid accidentally
pressing it while the router is operational. To press the Reset button, use a sharp narrow tool. Table 2 describes
the effects of pressing the Reset button.
Table 34:
BehaviorPress
Duration
Pressing for two seconds resets and reboots the router.Short press
Pressing for 10 seconds resets the router and reboots it with factory default configuration.Long press
SD Card Slot
The front panel of the vEdge 1000 router has an SD card slot. The SD card slot has the following specifications:
• Normal speed bus: maximum 10 MB/second
• Supported card types: SD, SDHC
Supported Transceivers
This article provides a list of copper and fiber transceivers that have been tested and qualified for use in vEdge
1000 and vEdge 2000 routers. You can order the transceivers that have a Viptela part number in the tables
below directly from Viptela.
Table 35:
DescriptionvEdge
5000
Router
vEdge
2000
Router
vEdge
1000
Router
Viptela Part
Number
Manufacturer & Part
Number
• Small form-factor pluggable
(SFP) transceiver
• RJ45-type connector
• 10/100/1000-Mbps Ethernet
XXXSFP-1GE-Base-TFinisar FCLF-8521-3
• SFP transceiver
• RJ45-type connector
• 10/100/1000-Mbps Ethernet
XXXSFP-1GE-Base-TFinisar
FCLF8521P2BTL
• SFP transceiver
• RJ45-type connector
• 10/100/1000-Mbps Ethernet
XXXCisco-Avago
SFBR-5766PZ-CS2
Hardware Installation Guide for vEdge Routers
117
vEdge 1000 Router
Supported Transceivers

Cisco vEdge Series Specifications

General

Connectivity Technology	Wired
Virtualization Support	Yes
High Availability	Yes
QoS Support	Yes
Product Type	Router
Data Link Protocol	Ethernet
Routing Protocols	BGP, OSPF
Interfaces	Gigabit Ethernet
Operating System	Cisco vEdge OS
Security	IPSec
Management	CLI