Cisco vEdge Series - Vedge 100 Router Default Configuration

You can download the Windows driver here .
To use the USB console from a Macintosh device:
1. Install the USB serial drivers attached here .
2. Launch the Terminal utility.
3. From a terminal shell, access the console port with this command:
$ screen /dev/tty.usbserial* 115200,cs8
vEdge 100 Router Default Configuration
The default configuration file looks like this:
vEdge100# show running-config
system
vbond ztp.viptela.com
aaa
auth-order local radius tacacs
usergroup basic
task system read write
task interface read write
Hardware Installation Guide for vEdge Routers
19
vEdge 100 Router
vEdge 100 Router Default Configuration