Cisco vEdge Series - Vedge 2000 Router Default Configuration

Note: It is recommended that you purchase the optical transceivers and optical connectors for your vEdge
routers from Viptela.
Warning: Do not look directly into a fiber-optic transceiver or into the ends of fiber-optic cables. Fiber-optic
transceivers and fiber-optic cables connected to a transceiver emit laser light that can damage your eyes.
vEdge 2000 Router Default Configuration
The default configuration file looks like this:
vEdge2000# show running-config
system
vbond ztp.viptela.com
aaa
auth-order local radius tacacs
usergroup basic
task system read write
task interface read write
!
usergroup netadmin
!
usergroup operator
task system read
task interface read
task policy read
task routing read
task security read
!
user admin
password
$6$t.vzhbSwOUaaCnRu$<wbr/>AiJYG3VFR1NurXPY7YXSputMMv4hg3<wbr/>Bign362rj4IIWXm7uVfiReqv/<wbr/>4EhKG2QUJSaZnZZPveQYBfIozCioyE<wbr/>/
!
!
logging
disk
enable
!
!
!
omp
Hardware Installation Guide for vEdge Routers
202
vEdge 2000 Router
vEdge 2000 Router Default Configuration