Cisco vEdge Series User Manual

When the dongle is enabled, vManage NMS displays PIM in the Hardware Type column and Wireless WAN
module in the Description column.
Enable the USB Controller using the CLI
To use the CLI to enable the USB controller:
1. Enter configuration mode:vEdge# config vEdge(config)#
2. Enable the USB controller:vEdge(config)# system usb-controller The following warnings were generated:
'system usb-controller': For this configuration to take effect, this command will cause an immediate device
reboot
3. Type yes to immediately reboot the router:Proceed? [yes, no] yes Starting cleanup Stopping viptela
daemon: sysmgr. Rebooting now Broadcast message from root@vEdge (pts/1) (Fri Apr 15 09:53:07
2016): The system is going down for reboot NOW!
After the router completes rebooting, the USB dongle is enabled
To verify that the dongle is enabled, use the following command:
vEdge# show hardware environment
When the dongle is enabled, the command output displays PIM in the Hardware Type column and Wireless
WAN module in the Description column.
Planning and Installation
This article provides general safety standards to adhere to when installing or connecting a vEdge 1000 router
or its components.
General Safety Standards
• Install your vEdge router in compliance with the following local, national, and international electrical
codes:
• United States—National Fire Protection Association (NFPA 70), United States National Electrical
Code.
• Other countries—International Electromechanical Commission (IEC) 60364, Part 1 through Part
7.
• Evaluated to the TN power system.
• Canada—Canadian Electrical Code, Part 1, CSA C22.1.
• Locate the emergency power-off switch in the room in which you are working. In case of an electrical
accident, quickly turn off the power.
• Disconnect power before installing or removing the router.
• If an electrical accident occurs, use caution and immediately turn off power to the router.
• Make sure that grounding surfaces are thoroughly cleaned and well-finished before grounding connections
are made.
Hardware Installation Guide for vEdge Routers
130
vEdge 1000 Router
Planning and Installation

Cisco vEdge Series Specifications

General

Connectivity Technology	Wired
Virtualization Support	Yes
High Availability	Yes
QoS Support	Yes
Product Type	Router
Data Link Protocol	Ethernet
Routing Protocols	BGP, OSPF
Interfaces	Gigabit Ethernet
Operating System	Cisco vEdge OS
Security	IPSec
Management	CLI