GuidelinesRack Requirement
It is recommended that the rack comply with the size and strength standards of a
19-inch rack as defined in Cabinets, Racks, Panels, and Associated Equipment
(document number EIA-310–D), published by the Electronics Industry Association
http://www.eia.org . Ensure that the rack rails are spaced widely enough to
accommodate the external dimensions of the chassis and that the outer edges of
the front mount brackets extend the width of the chassis to 19 in. (48.2 cm). You
must also ensure that the spacing of rails and adjacent racks allows for the proper
clearance around the router and rack.
Rack size
For maximum stability, secure the rack to ceiling brackets and to floor brackets.Rack secured to
building structure
Install the vEdge 100b Router
Once you have prepared your site for router installation, unpack the vEdge 100b router and mount it either
on the wall or in a 19-inch rack.
Unpack the vEdge 100b Router
A vEdge 100b router is shipped in a cardboard carton and secured firmly in place with foam packing material.
The carton contains a packing list and Quick Start instructions. It is recommended that you do not unpack the
router till you are ready to install it.
To unpack the router:
1. Open the top flaps of the carton.
2. Gradually remove the packing foam holding the router and the accessories in place. See Figure 1.
3. Take out the router and each accessory.
4. Verify the router components against the packing list included in the box (see packing list below).
Figure 1: Unpacking the vEdge 100b Router
Hardware Installation Guide for vEdge Routers
36
vEdge 100b Router
Install the vEdge 100b Router
To Next Page
Loading...
Need help?
General
