Cisco vEdge Series User Manual

You can download the Windows driver here .
To use the USB console from a Macintosh device:
1. Install the USB serial drivers attached here .
2. Launch the Terminal utility.
3. From a terminal shell, access the console port with this command:
$ screen /dev/tty.usbserial* 115200,cs8
Warning: Power over Ethernet (PoE) enabled cables can damage the console port. Do not accidentally connect
these cables to the console port.
Note: The management console is also accessible via a USB Type B interface on the front panel of the vEdge
2000 router . The USB Type B interface can be connected to a computer using a USB Type A or Type B cable
that is shipped with the router.
Step 4: Connect the Router to a Network for Out-of-Band Management
You can monitor and manage the vEdge 2000 router using a dedicated management channel.
To connect the vEdge 2000 router to a network for out-of-band management:
Hardware Installation Guide for vEdge Routers
197
vEdge 2000 Router
Connect the vEdge 2000 Router

Cisco vEdge Series Specifications

General

Connectivity Technology	Wired
Virtualization Support	Yes
High Availability	Yes
QoS Support	Yes
Product Type	Router
Data Link Protocol	Ethernet
Routing Protocols	BGP, OSPF
Interfaces	Gigabit Ethernet
Operating System	Cisco vEdge OS
Security	IPSec
Management	CLI