Cisco WRP500 Administration Guide

REVIEW DRAFT #1—CISCO CONFIDENTIAL
A-23
Cisco WRP500 Administration Guide
Appendix A Advanced Voice Fields
Regional page
CID Deact Code Disables caller ID generation.
The default is *85.
CWCID Act Code Enables call waiting, caller ID generation.
The default is *25.
CWCID Deact Code Disables call waiting, caller ID generation.
The default is *45.
Dist Ring Act Code Enables the distinctive ringing feature.
The default is *26
Dist Ring Deact Code Disables the distinctive ringing feature.
The default is *46.
Speed Dial Act Code Assigns a speed dial number.
The default is *74.
Secure All Call Act
Code
Makes all outbound calls secure.
The default is *16.
Secure No Call Act
Code
Makes all outbound calls not secure.
The default is *17.
Secure One Call Act
Code
Makes the next outbound call secure. (It is redundant if all outbound
calls are secure by default.)
The default is *18.
Secure One Call Deact
Code
Makes the next outbound call not secure. (It is redundant if all
outbound calls are not secure by default.)
The default is *19.
Conference Act Code If this code is specified, the user must enter it before dialing the
third party for a conference call. Enter the code for a conference
call.
Attn-Xfer Act Code If the code is specified, the user must enter it before dialing the third
party for a call transfer. Enter the code for a call transfer.
Modem Line Toggle
Code
Toggles the line to a modem.
The default is *99. Modem pass-through mode can be triggered
only by pre-dialing this code.
FAX Line Toggle
Code
Toggles the line to a fax machine.
The default is #99.

Cisco WRP500 Specifications

General

Brand	Cisco
Model	WRP500
Category	Wireless Router
Language	English