Contents
xxv
Catalyst 3560 Switch Software Configuration Guide
78-16156-01
Configuring Other OSPF Parameters 30-33
Changing LSA Group Pacing 30-35
Configuring a Loopback Interface 30-35
Monitoring OSPF 30-36
Configuring EIGRP 30-37
Default EIGRP Configuration 30-38
Configuring Basic EIGRP Parameters 30-39
Configuring EIGRP Interfaces 30-40
Configuring EIGRP Route Authentication 30-41
Monitoring and Maintaining EIGRP 30-42
Configuring BGP 30-43
Default BGP Configuration 30-45
Enabling BGP Routing 30-47
Managing Routing Policy Changes 30-49
Configuring BGP Decision Attributes 30-50
Configuring BGP Filtering with Route Maps 30-52
Configuring BGP Filtering by Neighbor 30-53
Configuring Prefix Lists for BGP Filtering 30-54
Configuring BGP Community Filtering 30-55
Configuring BGP Neighbors and Peer Groups 30-57
Configuring Aggregate Addresses 30-59
Configuring Routing Domain Confederations 30-59
Configuring BGP Route Reflectors 30-60
Configuring Route Dampening 30-61
Monitoring and Maintaining BGP 30-62
Configuring Protocol-Independent Features 30-63
Configuring Cisco Express Forwarding 30-63
Configuring the Number of Equal-Cost Routing Paths 30-64
Configuring Static Unicast Routes 30-65
Specifying Default Routes and Networks 30-66
Using Route Maps to Redistribute Routing Information 30-67
Configuring Policy-Based Routing 30-71
PBR Configuration Guidelines 30-72
Enabling PBR 30-72
To Next Page
Loading...
