Cisco WS-C3560-48PS-S - Page 24

Contents
xxiv
Catalyst 3560 Switch Software Configuration Guide
78-16156-01
CHAPTER 30 Configuring IP Unicast Routing 30-1
Understanding IP Routing 30-2
Types of Routing 30-2
Steps for Configuring Routing 30-3
Configuring IP Addressing 30-4
Default Addressing Configuration 30-4
Assigning IP Addresses to Network Interfaces 30-5
Use of Subnet Zero 30-6
Classless Routing 30-6
Configuring Address Resolution Methods 30-8
Define a Static ARP Cache 30-9
Set ARP Encapsulation 30-10
Enable Proxy ARP 30-10
Routing Assistance When IP Routing is Disabled 30-11
Proxy ARP 30-11
Default Gateway 30-11
ICMP Router Discovery Protocol (IRDP) 30-12
Configuring Broadcast Packet Handling 30-13
Enabling Directed Broadcast-to-Physical Broadcast Translation 30-13
Forwarding UDP Broadcast Packets and Protocols 30-14
Establishing an IP Broadcast Address 30-15
Flooding IP Broadcasts 30-16
Monitoring and Maintaining IP Addressing 30-17
Enabling IP Unicast Routing 30-18
Configuring RIP 30-19
Default RIP Configuration 30-19
Configuring Basic RIP Parameters 30-20
Configuring RIP Authentication 30-21
Configuring Summary Addresses and Split Horizon 30-22
Configuring IGRP 30-23
Default IGRP Configuration 30-24
Understanding Load Balancing and Traffic Distribution Control 30-25
Configuring Basic IGRP Parameters 30-26
Configuring Split Horizon 30-27
Configuring OSPF 30-28
Default OSPF Configuration 30-29
Configuring Basic OSPF Parameters 30-30
Configuring OSPF Interfaces 30-31
Configuring OSPF Area Parameters 30-32