Citrix ADC MPX
To avoid a shock hazard:
• Do not connect or disconnect any cables or perform installation, maintenance, or reconfigura‑
tion of this product during an electrical storm.
• Connect all power cords to a properly wired and grounded electrical outlet.
• Connect to properly wired outlets any equipment that is attached to this product.
• When possible, use one hand only to connect or disconnect signal cables.
• Never turn on any equipment when there is evidence of fire, water, or structural damage.
• Disconnect the attached power cords, telecommunications systems, networks, and modems
before you open the device covers, unless instructed otherwise in the installation and configu‑
ration procedures.
• Connect and disconnect cables as described in the following table when installing, moving, or
opening covers on this product or attached devices.
Connect cables
• Shut OFF all power sources and equipment to be attached to this product.
• Attach all cables to the devices.
• Attach signal cables to the connectors.
• Attach power cords to power sources. For DC systems, ensure correct polarity of ‑48 VDC con‑
nections: RTN is (+) and ‑48 VDC is (‑). Earth ground must use a two‑hole lug for safety.
• Turn ON all the power sources.
Disconnect cables
• Shut OFF all power sources and equipment to be attached to this product.
• For AC systems, remove all power cords from the shelf power receptacles or interrupt power at
the ac power distribution unit.
• For DC systems, disconnect DC power sources at the breaker panel or by turning o the power
source, then remove the DC cables.
• Remove the signal cables from the connectors.
• Remove all cables from the devices
Statement 2:
Caution: When laser products (such as CD‑ROMs, DVD drives, fiber optic devices, or transmitters) are
installed, note the following:
• Do not remove the covers. Removing the covers of the laser product might result in exposure to
hazardous laser radiation. There are no serviceable parts inside the device.
• Use of controls or adjustments or performance of procedures other than the ones specified here
might result in hazardous radiation exposure.
© 1999–2023 Cloud Soware Group, Inc. All rights reserved. 125
To Next Page
Loading...
Need help?
General
