EasyManua.ls Logo

Clear-Com FreeSpeak Edge - Page 12

Clear-Com FreeSpeak Edge
99 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
FreeSpeak Edge | User Guide
Eight transceivers, 6 channels:
The transceivers have selectable power settings, and these can be used to customize the size
of an RF cell to suit your environment and avoid the possibility of channels being placed next
to each other in the overall coverage zone.
When using FreeSpeak Edge, the channels are selected automatically by the EHX software in
the first instance.
For rapid set up you can use the default channels, but in any case you are advised to seek
information about existing 5 GHz traffic in your location. This information can be obtained
from:
l A site frequency coordinator or IT administrator (if there is one)
l A scan of channels in the location using the beltpack
Typically, the default channel setup will work for a small system (4 transceivers or less) in an
environment that has limited equipment competing for the band usage. For a larger system, or
one where there is more 5 GHz traffic, you are advised to take control of transceiver channel
selection yourself. RF channel selection can be changed in the EHXsoftware.
In most countries, 5Ghz channels fall into the following categories:
Page 12

Table of Contents

Other manuals for Clear-Com FreeSpeak Edge

Related product manuals