Menu item Description
System
l System connect. Use this to register
and connect the beltpack. The beltpack
must be registered to a system before
it can connect.
l System delete. Unregister the beltpack
from a previous system.
l Standalone mode (visible only in
standalone mode)
l Name (read only)
l IP address (read only)
l RF channel 1 (select available
channel)
l RF channel 2 (select available
channel)
l Tx power applied (select the
transceiver power in dBm).
Note: Only RF channels and RF power options that are compliant with Edge system WRR
(wireless regulatory region) are available on the beltpack's menu. The Edge system's WRR is
defined by the transceiver, which is the master device and contains a fixed WRR setting.
Menu item Description
Software info Software version information
Reset settings
This clears all preferences (audio, beltpack,
display) and roles to default settings (no role)
Reset to default
This clears all preferences and roles to
default AND clears all system registrations
Reboot Power cycle the beltpack
Shutdown Switch the beltpack off
Menu Access Level Select access level (pin protected)
To Next Page
Loading...
