CHAPTER4
STARTING AND OPERATlNG
INSTRUCTIONS
CHAPTER
4
STARTING AND OPERATING
INSTRUCTIONS
A. General Rreparation for Start-up - All Fuels
B.
Control Settings - Steam and Hot Water
C.
Gas Pilot
D.
Atomizing Air
E.
_Firing
Preparations for
No.2
Oil (Series 100-200)
F.
Firing Preparations for No. 6 Oil (Series 400-600)
G.
Firing Preparations for Gas (Series 200-400-700)
H. Start-up, Operating and Shutdown - All Fuels
I.
Control Operational Tests and Checks
NOTE:
If
your boiler is equipped with a
CB-HA
WKTM
boiler
manage-
ment control system, refer to CB-
HA
WK
Installation, Operating,
and Servicing Manual No.
750-
133 for
specific
information
regarding procedures described
in
this section.
A. GENERAL PREPARATION
FOR START-UP -
ALL
FUELS
Instructions
in
this chapter assume that installa-
tion
is
complete and that all electrical, fuel, water
and vent stack connections have been made.
The operator should be familiar with the burner,
boiler, and
all
controls and components. To
quickly locate and identify the various controls
750
..
150
and components mentioned
in
the following
paragraphs, refer
to
call-out photographs and the
contents
of
Chapter
1.
Adjustment
of
the major
components are given
in
Chapter 5 and this
should
be reviewed prior
to
frring. The wiring
diagram should also have been studied, along
with the sequence
in
Chapter 3.
!WARNING
It Is
recommended
that
these
starting
Instructions
be read
through
completely until
they
are
thoroughly
understood,
before
attempting to operate the
boiler,
rather
than
performing
each
operation as
it
is read for the
first
time. Failure
to
heed
this
warning
could result in serious personal
injury
or
death.
Verify the supply
of
fuel and the proper voltage.
Check for blown fuses, open circuit breakers,
dropped out overloads, etc. Check reset
of
all
CHAPTER
4-1
To Next Page
Loading...