Appendix A: 2-Wire Handset use
106 Operation
Operation
Make a call with the 2-Wire Handset
Making a call from a normal 2-wire POTS phone connected to one of the
two analogue POTS phone interfaces is done in the same way as a call from
a standard telephone, but always with the prefix 00 and
U after the
number to signal to the SwiftBroadband Unit, that the number is complete.
Example: To call Cobham SATCOM VA in USA (country code 1) first
establish a connection by pressing
or taking the handset
off the cradle. Then press the following keys on the phone:
TTJPNPMOLRNNPU
To learn how to make local calls see To make local phone calls on page 41.
Answer a call with the 2-Wire Handset
Answering a call to the Auxiliary handset can be done in two ways:
• If the handset is in the cradle, simply take the handset from the cradle to
answer the call.
• If the handset is out of the cradle, press
to answer the call.
Manage phone numbers in the 2-Wire Handset
The Auxiliary handset can store up to 10 phone numbers, in memory
location 0 to 9. The
A, B and C keys can be used for accessing
memory location 1, 2 and 3, whereas the other locations are accessed using
the MEM key followed by the number of the location.
To store a number using
A
,
B
and
C
Do as follows:
1. Press
or take the handset off the cradle.
2. Press
G.
To Next Page
Loading...
Need help?
General
