Chapter 1: Introduction
Services, features and interfaces 5
1111
Interfaces
The AVIATOR 200/300/350 system has the following interfaces:
Two 2-wire connections for telephone
One ISDN interface
Six Ethernet interfaces
One Wireless interface (WLAN) IEEE 802.11 b/g
One Ethernet interface for system configuration on the SBU front plate
(It is used for installation, service and maintenance. It is not used during
flight time.)
Built-in router and Wireless options
The AVIATOR 200/300/350 system offers a built-in router as an option.
With this option multiple users and applications can use the system
simultaneously. Without this option only the first device that connects to
the SBU will be allowed on the Internet.
The system also offers a built-in WLAN option for wireless communication
devices and a WLAN antenna approved for aeronautical use. This includes
full WLAN routing functionality.
If ordered, these options are enabled in the AVIATOR 200/300/350 from
the factory. If these options are not included from the start, the system can
be upgraded at a later stage. Then you receive the FLEX key for the
purchased options and enter it in the AVIATOR 200/300/350 web interface.
PBX telephone exchange
The built-in PBX telephone exchange unit of the SBU connects two direct 2-
wire POTS interfaces for faxes, handsets, headset interface boxes etc., as
well as an ISDN interface for ISDN phones, fax machines or secure
The availability of some services depends on the installed satcom
antenna. Check the section Services on page 3 for an overview of
services available for the antenna types LGA, IGA and HGA.