Chapter 2: Get started
Access Internet, e-mail, etc. 19
2222
Practical instructions
To access the Internet or use your e-mail program do as follows:
1. Switch on your PC, PDA or Smartphone.
2. For LAN: Connect your LAN cable (standard Ethernet) between the
network connector on your computer and one of the LAN connectors
installed in the aircraft.
For WLAN: Check that the WLAN icon in the status bar of your
operating system indicates that the WLAN connection has been
established.
3. Start your application, e.g. Internet browser or e-mail program.
If you cannot establish a connection, the automatic activation of a
standard data connection may be disabled in your system. Then you can
start a connection manually.
How to establish a connection manually see Start or stop a Standard
connection on page 32 or Start or stop a Streaming connection on
page 33 for detailed instructions. To learn more about the web interface
see Access and navigate the web interface on page 69.
If you want to change the start-up mode of the standard data
connection contact your system administrator to change the setting in
your network user group for Automatic activation to Enabled or
Disabled. This is described in detail in the AVIATOR 200/300/350
Installation and maintenance manual.
To access the WLAN for the first time you must enter the
Network Name (SSID) and the encryption key, if any.
WLAN access details Your AVIATOR system
Network Name (SSID)
Encryption key
To Next Page
Loading...
