Chapter 2: Get started
20 Make the first call
Make the first call
Introduction
The following sections provide a short guide to making calls. For more
detailed information, see Make or answer a phone call on page 38.
If you want to use a SIP-enabled IP handset to make a call see Use a SIP-
enabled IP handset or smartphone on page 51.
Make a call (air to ground)
To make a call from a phone or handset connected to the system, press
00 <country code> <phone number> followed by # or off-hook key.
Example: To call Cobham SATCOM VA in USA that has the country code
1 and the phone number 7574639557 press
00 1 7574639557 #
Call a handset in the aircraft (ground to air)
You find the voice numbers in the documentation in the aircraft cabin or
from your service provider. They may also figure on the quick guide. Make
sure you have the international dialling code for the country you want to
call from.To make a call to a phone connected to the AVIATOR
200/300/350 system (ground to air), dial
+ <Mobile number>
• + is the prefix used in front of the country code for international calls.
The Prefix depends on from which country you make the call. It is 011 if
you call from the USA.
• Mobile number: The mobile number of the system you are calling. The
first part of the number is always 870, which is the “country code” for
the SwiftBroadband system.
There are two Voice numbers, one for 3.1 kHz Audio and one for
Standard Voice.
To Next Page
Loading...
