Chapter 3: Operate the system
52 Use a SIP-enabled IP handset or smartphone
Set up a SIP-enabled wireless IP handset
To set up a SIP enabled IP handset, do as follows:
1. Connect to the Wireless access point of the AVIATOR system.
Check that the WLAN icon in the handset display indicates that the
WLAN connection has been established. If your WLAN is encrypted
check with your system administrator how to proceed to access the
encrypted WLAN network.
2. Connect to the SIP server of the AVIATOR 200/300/350 system. See the
user manual of your IP handset for guidelines how to establish a
connection to a SIP server. For this you may need to enter the following
details into the device:
• SIP server name, port and address, default: 192.168.0.1
•User name
•Password
•Codec priority
•Realm
• Audio configuration, Silence support
User name: When connecting to a SwiftBroadband Unit, the user name
should be a local number, i.e. 05xx. This must be configured in the built-in
web interface under SETTINGS > IP handsets.
Password: When connecting to a SwiftBroadband Unit, the password is the
local number for this phone. It is a number in the range of 0501 to 0516
which is not yet assigned to other IP phones. The password must match the
IP Handset password entered in the SwiftBroadband Unit.
Codec priority: Select the codec type that should have the highest
priority. You may select G.711 A-LAW.
Realm: If asked for Realm, enter the serial number of the AVIATOR
200/300/350 SBU.
Audio configuration, Silence support enable: Set to no. The phone
should not stop sending data packets even though there is silence and no
one speaks.
To Next Page
Loading...
