Chapter 4: Using the web interface
98-129217-D Introduction 48
Accessing and navigating the web interface
Accessing the web interface
To access the web interface, do as follows:
1. Connect your computer to the terminal.
2. Start up the terminal.
For details, see Getting started on page 11.
3. Open your browser and enter http://ut.bgan or the IP address of the terminal in the
address bar.
If your connected computer is set up to obtain a DNS server address automatically, this
name is translated into the local IP address of the terminal. The default IP address of the
terminal is http://192.168.0.1.
Changing the language
When you have access to the web interface, if you want to display a different language than
English, select SETTINGS > LANGUAGE from the left menu, select a language from the list
and click Apply. For further information, see Selecting the language on page 100.
If the IP address is changed and you do not have the new address, you can
temporarily set the IP address to the default value by pressing the Reset button next
to the SIM slot in the connector panel of the terminal. You can then access the web
interface and change the IP address.
Note that if you do not change the IP address, the default IP address will only be valid
until the terminal is powered off. Then the terminal returns to the IP address from
before the Reset button was pressed.
For further information on the Reset button, see Reset button on page 139.
To Next Page
Loading...
