Using lists
96 2110 SSB Transceiver Reference Manual
Changing a setting in the Control List
Most of the entries in the Control List contain a single setting. The steps in this section
show you how to change these settings. The Address entry, which contains multiple
settings, is covered on page 69, Entering your station self address.
To change a setting in the Control List:
1 Press until Main Menu is displayed.
1 Scroll to Control, then press .
1 Scroll to the entry in which the setting you want to change is stored, then hold .
A question mark is displayed at the end of the heading to show that you can now edit
the setting. For example:
1 Scroll to the value you want (if it is a slider screen or a list) or enter text (for help see
page 52, Entering and editing text).
If you do not want to save the change you made and you are in a setting where you
can:
• select a value from a list or slider screen, press or PTT
• enter and delete text, hold or press PTT
The change is discarded and the setting is closed.
1 Press .
The question mark is removed.
1 Press until Main Menu is displayed.
NOTE
In the following example, you will need to log in as administrator to see
the Control List (see page 110, Logging into admin level from user level).
NOTE
Scroll to the entry or use the Find feature (for help see page 64,
Finding words and values).
To Next Page
Loading...
Need help?
General
