Operating the transceiver
2110 SSB Transceiver Reference Manual 67
Setting the basics
Setting the time and date
When the transceiver leaves the factory it is set to UTC time with a time zone offset of
zero. To set your local time and date you need to enter your time zone offset from UTC
time, then adjust the local time and date if necessary. This feature is useful if you have a
network that spreads over several time zones, or you need to time stamp your
transmissions according to the current time at longitude zero.
Setting the time zone offset
To set your time zone offset from UTC time:
1 Press until Main Menu is displayed.
1 Scroll to Control, then press .
1 Scroll to Time Zone Offset, then hold .
1 Scroll to the correct time zone offset for your location, then press .
1 Press until Main Menu is displayed.
NOTE
In the following discussion, you will need to log in as administrator to see
the Main Menu (see page 110, Logging into admin level from user level).
NOTE
Scroll to the entry or use the Find feature (for help see page 64,
Finding words and values).
To Next Page
Loading...
Need help?
General
