Operating the transceiver
2110 SSB Transceiver Reference Manual 49
If the transmit and receive frequencies are the same, the frequency is only displayed in
the receive frequency position on the right side of the screen and the Rx indicator arrow
is not used. The signal strength/output power indicator shows whether the transceiver is
receiving or transmitting.
Your transceiver has the option of selecting high or low power by pressing Tx PWR.
When low power is selected, Lo is displayed to the right of the signal strength indicator
(see Figure 9). When high power is selected, Hi is displayed in this location.
While a call is being established, the transceiver will show that calling activity is in
progress by flashing CALL in place of the scan indicator (see Figure 10). During a call,
this indicator is replaced with an icon showing the type of call being sent or received (see
Figure 9). These icons are listed in Table 17 on page 158 and Table 18 on page 166.
When the transceiver is scanning, the channel screen is replaced by the scanning screen
(see Figure 10).
Figure 10: The scanning screen
scan indicator
To Next Page
Loading...
Need help?
General
