Operating the transceiver
62 2110 SSB Transceiver Reference Manual
Scanning channels
If you expect to receive calls on several channel/modes, switch scanning on. When
scanning is switched on the transceiver selects each channel/mode in your network in
quick succession to detect incoming calls. The channel/modes are scanned in a
continuous cycle. Mute is switched on automatically.
When the transceiver detects a call addressed to your station it stops scanning and
notifies you according to the type of call received (see page 190, Receiving a call). When
you press SCAN to end the call, scanning resumes. If you do not press this key to end
the call, or any other key within 30 seconds, the transceiver automatically ends the call
and resumes scanning.
When the transceiver detects voice it notifies you according to the mute setting selected
(see page 61, Muting the transceiver). If your transceiver is set to notify you when voice
is detected you can pause scanning, select the channel/mode on which the voice was
heard, then resume scanning when required.
It is recommended that scanning is switched on when you are not using the transceiver to
communicate.
Switching scanning on or off
To switch scanning on or off:
1 Press SCAN.
If a call is not in progress, scanning is toggled on or off.
If a call is in progress, the call is ended and the transceiver begins scanning.
Pausing scanning
To pause scanning:
1 Do one of the following:
• to pause scanning on the current channel/mode, press
• to pause scanning and scroll to another channel/mode, press or
The channel/modes through which you can scroll are those in the network or
networks that were being scanned. They are not listed alphabetically but in the order
in which they were being scanned.
If you do not press a key within 30 seconds, the transceiver automatically resumes
scanning.
1 While scanning is paused, do one or more of the following:
• to speak, hold down PTT
• to resume scanning immediately, press
NOTE
When scanning is switched on, mute is also switched on.
You cannot use the PTT button while the transceiver is scanning.
To Next Page
Loading...
Need help?
General
