Operating the transceiver
2110 SSB Transceiver Reference Manual 61
Muting the transceiver
When the transceiver is set to a channel or is scanning channels, you hear the noise on
each channel. If you do not want to listen to this noise you can silence the transceiver by
switching mute on. When the transceiver has been muted continuously for more than
10 seconds it will switch to low-current mode. The transceiver will return to full current
use when mute is opened. You can disable the low-current mode by setting the Cfg Low
Current Mode entry in the Control List to Disabled.
Mute automatically comes on when the transceiver starts scanning. You must set the
Mute Scan entry in the Control List to:
• Selcall if you want the mute to open when a call addressed to your station is detected
or voice is detected on a channel in a voice network
• Voice if you want the mute to open when a voice signal is detected (you can alter the
dwell time across Codan Selcall networks)
• Scan for Voice if you want the mute to open when a voice signal is detected on any
network (the transceiver scans at a uniform rate across all networks)
If the scan is paused due to voice being detected, the length of time that the transceiver
holds the pause is set in the Cfg Scan Voice Max Hold and Cfg Scan Voice Extend
entries in the Control List.
Switching mute on or off
To switch mute on or off:
1 Press MUTE.
A message is displayed briefly to inform you that mute has been switched on or off.
Setting the mute type
To select the mute type:
1 Press V/S to toggle the mute type between Selcall mute and Voice mute.
NOTE
In the following discussion, you will need to log in as administrator to see
the entries in the Control List (see page 110, Logging into admin level
from user level).
NOTE
For help on these entries in the Control List see page 200, Entries in the
Control List and page 96, Changing a setting in the Control List.
To Next Page
Loading...
Need help?
General
