The Channel List
2110 SSB Transceiver Reference Manual 119
Programming the Channel List
Creating a channel
This section covers creating a channel in a transceiver where receive and transmit
frequencies can be entered.
To create a channel:
1 Press VIEW until the channel screen is displayed.
1 Use the List Manager to create an entry (for help see page 97, Creating an entry in a
list and page 52, Entering and editing text).
1 Enter the setting information provided in the following table as required, then
press to enter the information.
NOTE
If you are operating the transceiver in a country that has stringent
licensing regulations, you may not be permitted to create channels with
transmit frequencies.
If the TxD option has been installed in the transceiver, there are
restrictions on the frequencies you can enter.
If the TxP option has been installed in the transceiver, you cannot create
channels.
NOTE If the Channel List is empty, Free Tune is displayed.
If this prompt is
displayed...
Do this...
Receive Freq • use this frequency, or
• enter a new receive frequency in kilohertz
NOTE
You can enter the frequency to three decimal
places. Press
*
to enter a decimal point, then
continue with entering the frequency.
Transmit Freq • use this frequency, or
• enter a new transmit frequency in kilohertz, or
• disable the transmit frequency by pressing
repeatedly until the setting is empty
NOTE
If the TxD option has been installed in the
transceiver, you cannot create channels with
new transmit frequencies. You can however,
create channels with the same transmit
frequency as an existing channel, and you
can disable transmit frequencies to create
receive-only channels.
To Next Page
Loading...
Need help?
General
