Using lists
2110 SSB Transceiver Reference Manual 101
Hiding and showing settings
You can set up the transceiver to show the first setting for each entry in a list. This shows
the information in the entry.
Figure 19 shows an entry (Call Base) in the Address List with the first setting for the
entry (call type and address) displayed under it. The setting is indented to indicate that it
belongs to the entry above it.
Figure 19: The Address List with settings shown
If you do not want the first setting to be displayed you can hide it.
The next entry in the list is displayed instead, as shown in Figure 20.
Figure 20: The Address List with settings hidden
Hiding settings in a list
To hide settings in a list:
1 Go to the list in which you want to hide settings. For example:
1 Hold to open the List Manager.
NOTE
In the following examples, you will need to log in as administrator to see
the Control List (see page 110, Logging into admin level from user level).
entry
setting
entry
next entry
To Next Page
Loading...
Need help?
General
