Operating the transceiver
2110 SSB Transceiver Reference Manual 79
Reducing background noise with Easitalk
The Easitalk feature enables you to reduce the level of background noise that is present
when you listen to a channel.
If Easitalk is on when the transceiver begins scanning, it is automatically switched off. It
is switched on again when scanning pauses or stops.
Switching Easitalk on or off
To switch Easitalk on or off:
1 Press EASITALK.
The Easitalk entry in the Control List is displayed and the value is automatically
toggled on or off.
After about 2 seconds you are returned to the screen from which you began.
NOTE
Easitalk uses one of three DSP algorithms to reduce the background
noise. Depending on the conditions you may need to change the algorithm
in the Cfg Easitalk entry in the Control List. If you intend to change the
algorithm regularly, set up a hot key on the 5 key to go to the next
algorithm value in the Cfg Easitalk entry in the Control List (see
page 331, Example 4: changing a value to the next value in a list).
NOTE Easitalk is not available if the Voice Encryptor feature is active.
To Next Page
Loading...
Need help?
General
