Operating the transceiver
76 2110 SSB Transceiver Reference Manual
Tuning the antenna
Automatic tuning
If the transceiver is connected to an automatic antenna, it tunes the antenna automatically
when required.
To tune the antenna when you select a channel:
1 Select a channel in the Channel List (for help see page 51, Selecting a channel).
1 Press then release PTT.
A message is displayed to inform you that tuning has begun, and the transceiver
makes a series of short beeps. Tuning typically takes 1–2 seconds.
If tuning fails, a message is displayed to inform you of this, and the transceiver
makes an error beep. You may need to manually tune the antenna (see page 77,
Manual tuning).
Removing the tuning message
To remove the tuning message before tuning is complete:
1 Press .
The beeps will continue until tuning is complete.
Aborting automatic tuning
To abort automatic tuning:
1 Press PTT.
A message is displayed to inform you that tuning has been aborted, and the
transceiver makes an error beep.
To Next Page
Loading...
