The Network List
2110 SSB Transceiver Reference Manual 129
The new network is created and the List Manager remains open.
1 If you want to view the network you have created, press to close the List
Manager.
Renaming a network
When you rename a network, references to the network in other lists are not
automatically updated; you need to go to the Address entry in the Control List to update
any of your station self addresses that refer to the network, and to the Address, NET and
Phone Link Lists to update any entries that refer to the network.
For example, if the network you renamed is used in an entry in the Address List, go to
this entry, find the reference to the old network name, then change it so that the new
name is displayed (for help see page 155, Editing an entry in the Address List). If you do
not update the reference to the network, the transceiver will prompt you to select a
network each time you use the entry to make a call.
Renaming a network is a standard list function. For help see page 98, Renaming an entry
in a list.
Copying a network
Copying a network is a standard list function. For help see page 99, Copying an entry in
a list.
Editing a network
Editing a network is a standard list function. For help see page 99, Editing an entry in a
list.
Deleting a network
Deleting a network is a standard list function. For help see page 100, Deleting an entry
from a list.
Mode? • select the mode for the channel or group of
channels that you want to use
Add another Channel/
Mode?
• select the channel/mode that you want to use
NOTE
If you do not want to add another channel/
mode, press .
If this prompt is
displayed...
Do this...
To Next Page
Loading...
Need help?
General
