About this manual
2110 SSB Transceiver Reference Manual 7
call detect time The length of time during scanning that the transceiver pauses
on each channel in order to detect an incoming call. It is the
inverse of the scan rate.
channel Frequencies programmed in the transceiver to transmit and
receive signals on air.
Channel Test call A call that enables you to test the quality of a channel. It is
sometimes referred to as a Beacon call. If you have the MIL-
STD-188-141B ALE option installed, Channel Test calls may be
made in an ALE/CALM network to replace information in the
LQA database, and to perform a manual sounding operation.
counterpoise A radial array or a grid network of metallic wires arranged
horizontally around the base of an antenna to provide an
effective earth plane.
Emergency call A call that enables you to trigger an emergency alert tone at a
specific station then speak to an operator there.
frequency The number of cycles per second of a radio wave, usually
expressed in kilohertz.
Get Position call A call that gets the GPS position of a specific station.
Get Status call A call that gets diagnostic information about the transceiver at a
specific station.
Group Selective call An ALE call that is sent to stations specifically addressed in the
call that are tuned to the same frequency in an ALE/CALM
network or scanning the network.
The Group Selective call may be used in Emergency, Message,
Phone, Selective, and Send Position calls if the MIL-STD-188-
141B ALE option is installed.
front panel The interface that is used to control the functions of the
2110 SSB Transceiver. It consists of a display, keypad and
connectors for the handset, antenna and earthing.
hot key A key on the front panel that is pre-programmed with a macro
that enables you to perform a task quickly.
Last Heard Log A log of the last 100 on-air transmissions detected by the current
station. The information gathered from each transmission
includes the self address of the heard station, the time/date of the
transmission, and the channel/mode used for the transmission.
The Last Heard Log is available if the MIL-STD-188-141B
ALE option is installed.
This term Means...
To Next Page
Loading...
Need help?
General
