Operating the transceiver
2110 SSB Transceiver Reference Manual 55
Deleting text
To delete text:
1 Use and to move the cursor one position to the right of the character that you
want to delete, then press .
Entering special characters in messages and names
To enter special characters:
1 Use the and keys to move the cursor to the point where you want to insert a
special character, then press
*
repeatedly until the symbol you want is displayed.
To enter one of an extended range of special characters:
1 Use and to move the cursor to the character or space where you want to replace
a character.
1 Press to place an underscore beneath the current character or space.
1 Use and to scroll through the character choices.
1 When you have selected the character that you want to use, use 1 or 3 to scroll left
or right respectively.
1 When you have made the changes, press to exit the special character mode.
NOTE
If you want to insert a space, make sure that A or a is displayed at the
bottom right of the screen before you press 0, otherwise you will
enter a zero.
NOTE
The special characters that are available are:
. , ’ ? ! & # $ * ( ) - + /
NOTE
Make sure that A or a is displayed at the bottom right of the screen
before you press
*
, otherwise you will enter a decimal point.
NOTE
The characters that are available are:
space , . ; ? : ¨ ‘ ’ / ! @ # $ % ^ & * ( ) _ - + = | \ ~ <
> { } [ ] 0 1 2 3 4 5 6 7 8 9
A B C D E F G H I J K L M N O P Q R S T U V W X Y Z
a b c d e f g h i j k l m n o p q r s t u v w x y z
NOTE
If you want to add a new character, enter a space then move the
cursor to this space.
To Next Page
Loading...
Need help?
General
