InteliLite4 AMF20 Global Guide
182
SMS
Event SMS
The InteliLite 4 controller equipped with the CM2-4G-GPS communication module is able to send Event SMS
according to the setting of setpoint:
Event Message (page 369)
Note: First, the setpoint Telephone Number 1 (page 350) must be adjusted to enable this function.
The following events can be received by mobile phone:
Engine Start/Stop
Manual Start/Stop
Remote Start/Stop
AMF Start/Stop (as Automatic Mains Failure Start/Stop)
Test Start/Stop Gen-set
Mains Fail
Mains Returned
Load on Mains
Load on Gen-set
Test On Load
Message structure:
Gen-set Name (hh:mm:ss dd.mm.yyyy)
hh:mm:ss Mains Fail
hh:mm:ss AMF Start
hh:mm:ss Load on Gen-set
hh:mm:ss Mains Returned
hh:mm:ss Load on Mains
hh:mm:ss AMF Stop
Alarm SMS
The InteliLite 4 controller equipped with the CM2-4G-GPS communication module is able to send Alarm SMS
according to the setting of setpoints:
Wrn Message (page 370)
Sd Message (page 370)
BOC Message (page 368)
Note: First, the setpoint Telephone Number 1 (page 350) must be adjusted to enable this function.
Message structure:
Gen-set Name
AL=(Alarm 1, Alarm 2, Alarm x)
Note: An asterisk means that alarm is unconfirmed and an exclamation mark means that alarm is active.
To Next Page
Loading...
