InteliLite4 AMF20 Global Guide
219
Reset To Manual
Setpoint group Basic settings Related FW 1.3.0
Range [units] Disabled / Enabled [-]
Default value Disabled Alternative config NO
Step [-]
Comm object 9983 Related applications AMF,MRS
Config level Advanced
Setpoint visibility Always
Description
If this function is enabled, the controller will switch automatically to MAN mode when there is a red alarm in
the alarm list and fault reset button is pressed. This is a safety function that prevents the Gen-set starting
again automatically in specific cases when fault reset button is pressed.
6 back to List of setpoints
Backlight Timeout
Setpoint group Basic settings Related FW 1.3.0
Range [units] Disabled / 1 .. 255 [min]
Default value Disabled Alternative config NO
Step 1 min
Comm object 10121 Related applications AMF,MRS
Config level Advanced
Setpoint visibility Always
Description
The display backlight is switched off when this timer exceed. When setpoint is adjusted to disabled then
the display will be backlighted all the time.
6 back to List of setpoints
To Next Page
Loading...
Need help?
General
