InteliLite4 AMF20 Global Guide
358
IP Firewall
Setpoint group CM-Ethernet Related FW 1.3.0
Range [units] ENABLED / DISABLED [-]
Default value DISABLED Alternative config NO
Step [-]
Comm object 23920 Related applications AMF,MRS
Config level Standard
Setpoint visibility Only if relevant module is installed
Description
This setpoints enables to switch on the built-in Firewall functionality.
DISABLED The firewall function is switched off
ENABLED
The firewall function is switched on, use InteliConfig to setup the firewall rules
(configuration card Others – Firewall)
6 back to List of setpoints
Subgroup:AirGate Settings
AirGate Connection
Setpoint group CM-Ethernet Related FW 1.3.0
Range [units] DISABLED / ENABLED [-]
Default value ENABLED Alternative config NO
Step [-]
Comm object 23935 Related applications AMF,MRS
Config level Standard
Setpoint visibility Only if relevant module is installed
Description
This setpoint selects the AirGate connection mode.
DISABLED: This is a standard mode in which the controller listens to the incoming traffic and
answers the TCP/IP queries addressed to it. This mode requires the controller to
be accessible from the remote device (PC), i.e. it must be accessible at a public
and static IP address if you want to connect to it from the internet.
ENABLED This mode enables the AirGate service. The AirGate server address is adjusted by
the setpoint AirGate Address (page 359). Also the standard TCP/IP is enabled.
6 back to List of setpoints
To Next Page
Loading...
Need help?
General
