ComAp InteliLite AMF25 User Manual

InteliLite Global Guide
146
Web Server
IMPORTANT: The web interface is based on HTTP protocol and is intended to be used only in
private networks. It is not recommended to expose the web interface to the public Internet.
The Web Server is designed for basic monitoring and adjustment of the controller using a web browser. Just put
the controller IP address into the browser to display the main controller web page like http://192.168.1.254. You
will be asked for the controller access code prior to entering the web pages.
IMPORTANT: Do not use the browser navigation buttons as "Back", "Forward" or "Reload". Use
the links and the reload button located in the toolbar instead.
Note: Only two remote clients can be connected to the Web Server at one moment. If you close your web
browser without disconnecting from the CM-Ethernet ("Exit" button at the web pages), the connection will be
blocked for next 5 minutes.
Image 6.7 Web Server main screen

ComAp InteliLite AMF25 Specifications

General

Inputs	8 binary inputs
Outputs	8 binary outputs
Power Supply	8-36 V DC
Communication	RS232, RS485
Operating Temperature	-20°C to +70°C
Supported Generators	Diesel, gas
Controller Type	Automatic Mains Failure Controller
Protection	IP65