ComAp InteliLite AMF25 User Manual

InteliLite Global Guide
374
Setpoint group
CM-GPRS; CM-4G-
GPS; CM-Ethernet
Related FW 1.9.0
Range [units] GMT-12:00 .. GMT+13:00 [hours]
Default value GMT+1:00 hour Alternative config NO
Step [-]
Comm object 24366 Related applications AMF, MRS
Config level Standard
Setpoint visibility Only if relevant module is installed
Description
This setpoint is used to select the time zone where the controller is located. See your computer time zone
setting (click on the time indicator located in the rightmost position of the Windows task bar) if you are not
sure about your time zone.
Note: If the time zone is not selected properly the active e-mails may contain incorrect information about
sending time, which may result in confusion when the respective problem actually occurred.
Note: This setpoint is common for CM-Ethernet, CM-GPRS and CM-4G-GPS modules.
Time Zone
6 back to List of setpoints
Setpoint group
CM-GPRS; CM-4G-
GPS; CM-Ethernet
Related FW 1.9.0
Range [units] ON / OFF [-]
Default value ON Alternative config NO
Step [-]
Comm object 10926 Related applications AMF, MRS
Config level Standard
Setpoint visibility Only if relevant module is installed
Description
This setpoint enables or disables Event Messages.
This setpoint is common for CM-Ethernet, CM-GPRS and CM-4G-GPS modules.
Event Message
6 back to List of setpoints

ComAp InteliLite AMF25 Specifications

General

Inputs	8 binary inputs
Outputs	8 binary outputs
Power Supply	8-36 V DC
Communication	RS232, RS485
Operating Temperature	-20°C to +70°C
Supported Generators	Diesel, gas
Controller Type	Automatic Mains Failure Controller
Protection	IP65