ComAp InteliLite AMF25 User Manual

InteliLite Global Guide
383
Setpoint group CM-Ethernet Related FW 1.9.0
Range [units] Valid IP address [-]
Default value DISABLED Alternative config NO
Step [-]
Comm object 24293 Related applications AMF, MRS
Config level Standard
Setpoint visibility Only if relevant module is installed
Description
IP address 2 for receiving SNMP Traps. Leave this setpoint blank if SNMP traps should not be send.
SNMP Traps IP Address 2
6 back to List of setpoints
Setpoint group CM-Ethernet Related FW 1.9.0
Range [units] DISABLED / ENABLED [-]
Default value ENABLED Alternative config NO
Step [-]
Comm object 24365 Related applications AMF, MRS
Config level Standard
Setpoint visibility Only if relevant module is installed
Description
This setpoint selects the Ethernet connection mode.
DISABLED: This is a standard mode in which the controller listens to the incoming traffic and answers
the TCP/IP queries addressed to it. This mode requires the controller to be accessible
from the remote device (PC), i.e. it must be accessible at a public and static IP address if
you want to connect to it from the internet.
ENABLED This mode enables the AirGate service. The AirGate server address is adjusted by the
setpoint AirGate Address (page 384). Also the standard TCP/IP is enabled.
AirGate Connection
6 back to List of setpoints

ComAp InteliLite AMF25 Specifications

General

Inputs	8 binary inputs
Outputs	8 binary outputs
Power Supply	8-36 V DC
Communication	RS232, RS485
Operating Temperature	-20°C to +70°C
Supported Generators	Diesel, gas
Controller Type	Automatic Mains Failure Controller
Protection	IP65